/*
* Board initialization code should put one of these into dev->platform_data
* and place the isp116x onto platform_bus.
*/
#ifndef __LINUX_USB_ISP116X_H
#define __LINUX_USB_ISP116X_H
struct isp116x_platform_data {
/* Enable internal resistors on downstream ports */
unsigned sel15Kres:1;
/* On-chip overcurrent detection */
unsigned oc_enable:1;
/* INT output polarity */
unsigned int_act_high:1;
/* INT edge or level triggered */
unsigned int_edge_triggered:1;
/* Enable wakeup by devices on usb bus (e.g. wakeup
by attachment/detachment or by device activity
such as moving a mouse). When chosen, this option
prevents stopping internal clock, increasing
thereby power consumption in suspended state. */
unsigned remote_wakeup_enable:1;
/* Inter-io delay (ns). The chip is picky about access timings; it
expects at least:
150ns delay between consecutive accesses to DATA_REG,
300ns delay between access to ADDR_REG and DATA_REG
OE, WE MUST NOT be changed during these intervals
*/
void (*delay) (struct device *dev, int delay);
};
#endif /* __LINUX_USB_ISP116X_H */
y~or5J ={Eeu磝Qk ᯘG{?+]ן?wM3X^歌>{7پK>on\jy R g/=fOroNVv~Y+ NGuÝHWyw[eQʨSb> >}Gmx[o[<{Ϯ_qF vM IENDB`
