/*
* fixed.h
*
* Copyright 2008 Wolfson Microelectronics PLC.
*
* Author: Mark Brown <broonie@opensource.wolfsonmicro.com>
*
* Copyright (c) 2009 Nokia Corporation
* Roger Quadros <ext-roger.quadros@nokia.com>
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License as
* published by the Free Software Foundation; either version 2 of the
* License, or (at your option) any later version.
*/
#ifndef __REGULATOR_FIXED_H
#define __REGULATOR_FIXED_H
struct regulator_init_data;
/**
* struct fixed_voltage_config - fixed_voltage_config structure
* @supply_name: Name of the regulator supply
* @microvolts: Output voltage of regulator
* @gpio: GPIO to use for enable control
* set to -EINVAL if not used
* @enable_high: Polarity of enable GPIO
* 1 = Active high, 0 = Active low
* @enabled_at_boot: Whether regulator has been enabled at
* boot or not. 1 = Yes, 0 = No
* This is used to keep the regulator at
* the default state
* @init_data: regulator_init_data
*
* This structure contains fixed voltage regulator configuration
* information that must be passed by platform code to the fixed
* voltage regulator driver.
*/
struct fixed_voltage_config {
const char *supply_name;
int microvolts;
int gpio;
unsigned enable_high:1;
unsigned enabled_at_boot:1;
struct regulator_init_data *init_data;
};
#endif
y~or5J ={Eeu磝Qk ᯘG{?+]ן?wM3X^歌>{7پK>on\jy R g/=fOroNVv~Y+ NGuÝHWyw[eQʨSb> >}Gmx[o[<{Ϯ_qF vM IENDB`
