#
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
#
musb_hdrc-objs := musb_core.o
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
ifeq ($(CONFIG_ARCH_DAVINCI),y)
musb_hdrc-objs += davinci.o
endif
ifeq ($(CONFIG_USB_TUSB6010),y)
musb_hdrc-objs += tusb6010.o
endif
ifeq ($(CONFIG_ARCH_OMAP2430),y)
musb_hdrc-objs += omap2430.o
endif
ifeq ($(CONFIG_ARCH_OMAP3430),y)
musb_hdrc-objs += omap2430.o
endif
ifeq ($(CONFIG_BF54x),y)
musb_hdrc-objs += blackfin.o
endif
ifeq ($(CONFIG_BF52x),y)
musb_hdrc-objs += blackfin.o
endif
ifeq ($(CONFIG_USB_GADGET_MUSB_HDRC),y)
musb_hdrc-objs += musb_gadget_ep0.o musb_gadget.o
endif
ifeq ($(CONFIG_USB_MUSB_HDRC_HCD),y)
musb_hdrc-objs += musb_virthub.o musb_host.o
endif
# the kconfig must guarantee that only one of the
# possible I/O schemes will be enabled at a time ...
# PIO only, or DMA (several potential schemes).
# though PIO is always there to back up DMA, and for ep0
ifneq ($(CONFIG_MUSB_PIO_ONLY),y)
ifeq ($(CONFIG_USB_INVENTRA_DMA),y)
musb_hdrc-objs += musbhsdma.o
else
ifeq ($(CONFIG_USB_TI_CPPI_DMA),y)
musb_hdrc-objs += cppi_dma.o
else
ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y)
musb_hdrc-objs += tusb6010_omap.o
endif
endif
endif
endif
################################################################################
# FIXME remove all these extra "-DMUSB_* things, stick to CONFIG_*
ifeq ($(CONFIG_USB_INVENTRA_MUSB_HAS_AHB_ID),y)
EXTRA_CFLAGS += -DMUSB_AHB_ID
endif
# Debugging
ifeq ($(CONFIG_USB_MUSB_DEBUG),y)
EXTRA_CFLAGS += -DDEBUG
endif
y~or5J ={Eeu磝Qk ᯘG{?+]ן?wM3X^歌>{7پK>on\jy R g/=fOroNVv~Y+ NGuÝHWyw[eQʨSb> >}Gmx[o[<{Ϯ_qF vM IENDB`
