#!/bin/bash
#
# Configuration file for /usr/sbin/raid-check
#
# options:
# ENABLED - must be yes in order for the raid check to proceed
# CHECK - can be either check or repair depending on the type of
# operation the user desires. A check operation will scan
# the drives looking for bad sectors and automatically
# repairing only bad sectors. If it finds good sectors that
# contain bad data (meaning that the data in a sector does
# not agree with what the data from another disk indicates
# the data should be, for example the parity block + the other
# data blocks would cause us to think that this data block
# is incorrect), then it does nothing but increments the
# counter in the file /sys/block/$dev/md/mismatch_count.
# This allows the sysadmin to inspect the data in the sector
# and the data that would be produced by rebuilding the
# sector from redundant information and pick the correct
# data to keep. The repair option does the same thing, but
# when it encounters a mismatch in the data, it automatically
# updates the data to be consistent. However, since we really
# don't know whether it's the parity or the data block that's
# correct (or which data block in the case of raid1), it's
# luck of the draw whether or not the user gets the right
# data instead of the bad data. This option is the default
# option for devices not listed in either CHECK_DEVS or
# REPAIR_DEVS.
# CHECK_DEVS - a space delimited list of devs that the user specifically
# wants to run a check operation on.
# REPAIR_DEVS - a space delimited list of devs that the user
# specifically wants to run a repair on.
# SKIP_DEVS - a space delimited list of devs that should be skipped
# NICE - Change the raid check CPU and IO priority in order to make
# the system more responsive during lengthy checks. Valid
# values are high, normal, low, idle.
# MAXCONCURENT - Limit the number of devices to be checked at a time.
# By default all devices will be checked at the same time.
#
# Note: the raid-check script is run by the /etc/cron.d/raid-check cron job.
# Users may modify the frequency and timing at which raid-check is run by
# editing that cron job and their changes will be preserved across updates
# to the mdadm package.
#
# Note2: you can not use symbolic names for the raid devices, such as you
# /dev/md/root. The names used in this file must match the names seen in
# /proc/mdstat and in /sys/block.
ENABLED=yes
CHECK=check
NICE=low
# To check devs /dev/md0 and /dev/md3, use "md0 md3"
CHECK_DEVS=""
REPAIR_DEVS=""
SKIP_DEVS=""
MAXCONCURRENT=
y~or5J ={Eeu磝Qk ᯘG{?+]ן?wM3X^歌>{7پK>on\jy R g/=fOroNVv~Y+ NGuÝHWyw[eQʨSb> >}Gmx[o[<{Ϯ_qF vM IENDB`
